www.charltonandjenrick.co.uk
23
LT7272 (ISS 1)
REPLACEMENT OF GAS CONTROL TAP
1.
Turn off the gas supply by isolating cock.
2.
Lift away carefully fire fret.
3.
Lift away carefully all loose fuel bed components.
4.
Remove plastic knob from gas control tap.
5.
Disconnect gas supply from inlet elbow of appliance (right of gas control tap)
6.
Undo and remove four screws from bezel plate at front of appliance.
7.
Undo locknut on front of gas valve and lift away bezel plate.
8.
Undo and remove two screws securing the main burner tray inside the firebox.
9.
Lift burner tray away from the main casing.
10.
Disconnect the three compression gas connections from the gas control tap.
11.
Remove the ignition lead carefully from the pilot.
12.
Undo the thermocouple connection from the rear of the gas control tap.
13.
Service or replace gas control tap as necessary.
14.
Re-assemble the in reverse order.
15.
Turn on the gas supply, check for soundness and re commission appliance.
REPLACEMENT OF BURNER AND OR THE SILENCER
NOTE: The silencer must not be modified and must be correctly positioned in its bracket.
1.
Carefully remove all coals/pebbles and ceramic baseboards.
2.
Undo the two screws securing the burner in the top of the main coal support and remove burner and
silencer.
3.
Clean, service or replace as necessary.
4.
Re-assemble in reverse order. For pebble bed push burner to right side when tightening securing screws.
5.
Turn on gas supply, check for gas soundness and re commission appliance.
REPLACEMENT OF INJECTOR
1.
Repeat operations 1-2 for removal of burner and or silencer.
2.
Disconnect gas connection to injector.
3.
Unscrew the locking nut fixing injector to mounting bracket.
4.
Clean or replace as necessary.
5.
Re-assemble in reverse order pushing burner to right hand side for pebble bed before securing screws.
6.
Turn on gas supply, check for gas soundness and re- commission appliance.
REPLACEMENT OF OXY-PILOT ASSEMBLY
NOTE: If the pilot assembly is replaced it must be replaced by an identical unit from the same manufacturer and replaced as a
complete unit.
1.
Carefully remove all coals/pebbles and ceramic baseboards
2.
Disconnect gas supply.
3.
Remove 4 screws securing tray to firebox, 2 at base of bezel and 2 inside firebox and lift out tray.
4.
Disconnect the thermocouple from the gas control tap.
5.
Disconnect the gas connection from the pilot assembly.
6.
Remove ignitor lead from pilot assembly.
7.
Undo the two screws securing the oxy-pilot to the burner.
8.
Re-assemble the in reverse order.
9.
Turn on the gas supply, check for gas soundness and re-commission appliance.
Содержание Paragon P3
