Charlton & Jenrick Paragon Edge, Руководство пользователя

Страница: 33 / 40

www.charltonandjenrick.co.uk 33 LT8229 (ISS 3)
Replacement Of The Injector
Follow the sequence to remove the burner carrier assembly.
Undo the compression nut on the supply pipe.
Remove the two screw retaining the burner assembly to the carrier and lift away from the injector.
Unscrew the locking nut holding the injector and silencer bracket on the burner carrier.
Remove injectors from assembly. Clean or replace injector.
Re-assemble in reverse order.
Replacement of the Oxy-Pilot Assembly
Note: If the pilot assembly is replaced it must be replaced by an identical unit from the same manufacturer and
replaced as a complete unit.
Follow the sequence to remove the burner carrier assembly.
Undo the compression nut on the supply pipe at the pilot.
Carefully pull off the ignition lead.
Disconnect the thermocouple at the end of the gas valve.
Remove the two fixing screws attaching the assembly to burner carrier.
Re-assemble in the reverse order.
Replacement of the burner Assembly
Remove the glass panel as described in the users instruction section.
Remove the Loose shapes and the air tray assembly.
Undo the three fixing screws retaining the burner assembly with the carrier.
Lift the burner clear of the silencer and injector tip.
Clean or replace the burner assembly.
Re-assemble in reverse order.
Replacement of the Electronic Control Unit (ECU)
Remove the glass panel as described in the users instruction section.
Remove the Loose shapes and the air tray assembly.
Remove the burner carrier assembly.
Undo the one M3 nuts retaining the ECU unit.
Unplug the connection from the ECU board.
Re-assemble in reverse order.