Charlton & Jenrick Paragon Edge, Руководство пользователя

Страница: 31 / 40

www.charltonandjenrick.co.uk 31 LT8229 (ISS 3)
Run the match along the edge of the inlet air channel. All smoke must be drawn into the inlet channel if the spillage
test is satisfactory.
If spillage occurs wait a further five minutes and repeat the test.
Repeat the test with doors open and with any extractor fans in other rooms in operation.
If spillage is detected the cause must be discovered and the fault corrected. If the fault cannot be corrected.
Disconnect the fire from the gas supply and seek expert advice. Spillage can be caused by a restriction in the flue
system, down draught or insufficient ventilation into the room where the fire is installed.
ADVISE CUSTOMER THAT:
•
The glass front of this fire acts as a dress guard, conforming to BS 1945 (1997) and satisfies the heating
appliance regulations (1991) however; a fireguard conforming to BS6539 (1997) must be used to protect young
children, the elderly, or infirm.
•
The curing effect of heating the coals and other refractory components will cause an initial odour. This is due
to the starch used in the manufacturing process and is non-toxic.
•
Any debris should be cleaned from the appliance. A vacuum cleaner can be used but only after all the loose
log shapes and vermiculite has been removed.
•
The appliance should be serviced annually by a competent person in accordance with these instructions and
the appliance checked for spillage in accordance with the method detailed in these instructions.
•
Demonstrate the lighting and extinguishing procedures to the user. Refer to the user section of this booklet.
•
If ventilation is fitted for any reason it must be checked regularly to ensure freedom from obstructions.
Hand these instructions over to the user.