201003 - 5500W DUAL FUEL ELECTRIC START INVERTER GENERATOR
OPERATION
21
WARNING
Do not expose to rain or use in damp locations.
Keep all objects a minimum of 5 feet (1.5m) away from the
generator at all times. Heat from the muffler surface and
exhaust gas stream can ignite combustible materials.
WARNING
If you must operate in rain or damp locations, DO NOT operate
without proper protection of the electrical components.
Use of a safety canopy that is fire retardant and will provide proper
air ventilation for the engine exhaust gas stream may be used.
Visit championpowerequipment.com or call to find your Storm
Shield cover.
Surge Protection
Electronic devices, including computers and many programmable
appliances use components that are designed to operate within a
narrow voltage range and may be affected by momentary voltage
fluctuations. While there is no way to prevent voltage fluctuations,
you can take steps to protect sensitive electronic equipment.
–
Install UL1449, CSA-listed, plug-in surge suppressors on the
outlets feeding your sensitive equipment.
Surge suppressors come in single- or multi-outlet styles.
They’re designed to protect against virtually all short-duration
voltage fluctuations.
Starting the Engine: Gasoline
1. Make certain the generator is on a flat, level surface.
Electric Start
1. Disconnect all electrical loads from the generator. Never start
or stop the generator with electrical devices plugged in or
turned on.
2. Turn the EZ Start dial to the gasoline “CHOKE” position.
3. Press and hold the ignition switch to start the engine. Release
as the engine begins to start. If the engine fails to start within
five seconds, release the switch and wait at least ten seconds
before attempting to start the engine again.
4. Do not over-choke. As soon as engine starts, turn the EZ
Start dial to the gasoline “RUN” position.
CAUTION
If the ignition switch is held down in the “START” position
longer than 5 seconds it could damage the starter.
Manual Start
1. Disconnect all electrical loads from the generator. Never
start or stop the generator manually with electrical devices
plugged in or turned on.
2. Turn the EZ Start dial to the gasoline “CHOKE” position.
