Chamberlain Elite EL Series, Руководство по программированию

Страница: 38 / 80

Page 37
Entr
y Codes
Entr
y Codes
Assign Utility Option:
58
Press Then
Enter new or existing entry code (3-9). Then (#)
Option:
0 =Off
1 =Reset use daily at midnight
2 =Reset weekly
3 =Never reset
Number of uses (1-15)
Assign a limited use entry code. This feature allows the user to assign a fixed number of uses
for an entry code. The number of uses may reset daily or weekly. For example, allow a
temporary code use 4 times a day. Use the never reset option to give a fixed use until all tries
are used up.
Factory Setting: Off
Entry Code "1394" has 1 use resetting weekly for direct commands from the keypad.
Example:
8 9
1 2
3 4
1
2
3
4
Assign Special Use Entry Code at the Unit Keypad:
59
Press Then
Enter existing entry code (3-9) and hold down last digit for command prompts. Then (#)
Enable/Disable special use. Then (enable = 1, disable = 0) (#)
Table of responses for Action Codes: Voice is the primary response, if there is no voice then
beeps are played. When you hold down the last digit, you will hear “command” and then you
enter one of the command numbers.
Entry Code "1394" has the ability to execute an action at the main keypad.
Example:
9 9
1 2 3
1
2
3
NOTE: You may not assign utility codes with special use ability. When you hold down the last
digit, you will hear “command” and then you enter one of the command numbers.
Command Number Action
0 Release all Doors and return to previous schedule
1 Toggle Open/Close for Door 1
2 Toggle Open/Close for Door 2
3 Toggle Open/Close for Door 3
4 Toggle Open/Close for Door 4
5 Toggle Enable/Disable Resident Call Forward
6 Toggle Enable/Disable Resident Do Not Disturb
7 Get Door Status (Rolling). Each use reports status of next door. For
example used once the status may report door 1, used again then status
reports door 2, etc.
* The Open status means the door is currently opened by a Latch Command or in the Unlock
portion of an Automatic Schedule.
**The commands 5 and 6 play a single short beep when enabled or a single long beep when
disabled.