Challenger Lifts CLM16, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 57

Group Mode
Select "group mode" by pressing and holding this
button for approx. two seconds.
2 seconds
Activation of this operating mode is indicated by the
lit LED on the selector button and the letter
G
on
the seven-segment display.
The columns not in group mode are temporarily inoperative. This is indicated
by the letter A flashing on the seven-segment display.
WARNING
!!! SAFETY WARNING !!!
!!! DO NOT TILT VEHICLE !!!
Use these buttons to raise or lower the lift.
NOTE:
Height offsets between individual columns will be maintained after switch-
over to automatic mode. The offset can be removed either
– by equalizing the carriages in single or group mode or
– by lowering all carriages to bottom position in automatic mode.
Lift stops once first carriage reaches upward travel stop.
or
Trouble-Shooting Codes of Seven-Segment Display and LED Display
Error codes E5 and E6 are not used. This is to avoid confusion with the code letters for single
and group mode.
Error codes E4 and E8 are not used at present.
CLM16 IOM.
DOC
5/8/09
Error Code LED Description
A
or
S
or
G
Normal operation, no errors. See "Operating Modes: Automatic Mode /
Single Mode / Group Mode" in this manual.
green