Challenger Lifts CLM16, Инструкция по установке, эксплуатации и обслуживанию

Страница: 18 / 57

Control Elements
LED Display
Indicates operating and error states.
Selector Button (on Control Unit)
Use this button to select between:
Automatic mode (A)
Single mode (S)
Group mode (G)
Seven-Segment Display (on Control Unit)
Indicates operating and error codes.
RAISE Button (on Control Unit)
Press and hold this button to raise the lift. Lift stops once button is
released or upward travel stop is reached.
LOWER Button (on Control Unit)
Press and hold this button to lower the lift. Lift stops once button is
released or downward travel stop is reached.
Emergency Stop Button (on Control Unit)
In case of emergency press this button to interrupt all lift functions
immediately.
Pull out the button to make the lift ready for operation again.
Make sure that prior cause of emergency has been resolved
before operating the lift again!
Overload Protection:
The lift control is equipped with an automatic overload protection device, shutting the lift off, in case
the rated load capacity is exceeded. In such case, the control only allows the lowering of the lift.
Always ensure that the operator observes the maximum rated load capacity.
Lift Positioning
Use the lift on a hard, level surface only, preferably concrete (Keep the lifted weight in mind!)
Apply the parking brake after positioning the vehicle.
Push the support forks completely under the wheels/lift points of the vehicle.
Attach the power supply unit (P) to the control unit (C) of the column closest to the main power
supply in your building.
Interconnect the columns using connecting cables (1) between input terminals (IN) and output
terminals (OUT). Connect a dummy plug or the cable remote control (2) to the output terminal of the
last column.
CLM16 IOM.
DOC
5/8/09