7
F.200/TITAN 200/MAR 97
•
This machine is designed and safeguarded for ONE PERSON operation. NEVER operate the cutter with more
than one person.
•
Safety is the responsibility of the user of this machine. Use good judgement and common sense when working
with and around this machine.
•
READ and understand all instructions thoroughly before using the cutter. If questions still remain, call your
Authorized Challenge Dealer - fingers and hands are too valuable to risk experimentation.
•
Only trained and authorized persons should operate the cutter.
•
DO NOT ALTER SAFETY MECHANISMS, they are for your protection and should not be altered or removed.
Severe lacerations or dismemberment could result.
•
DISCONNECT POWER before cleaning, lubricating, servicing or making adjustments not requiring power. Turn
the main disconnect switch to the off position and disconnect the power plug, see Disconnect Procedure
below.
•
Be sure the cutter is properly grounded.
•
Be sure there is sufficient power to operate the cutter properly.
•
Observe all caution plates mounted on this cutter.
•
Keep foreign objects off table and away from cutter blade.
•
BE EXTREMELY CAREFUL when handling and changing the cutter knife. Severe
lacerations or dismemberment could result from careless handling procedures.
•
Keep the floor around the cutter free of trim, debris, oil and grease.
•
When replacing hydraulic parts, loosen the connections slowly to release pressure. Never
loosen connections with the machine running.
•
If the cutter sounds or operates unusually, turn it off and consult the troubleshooting section of this manual. If
the problem cannot be corrected, have it checked by a qualified service person.
•
CRUSH HAZARD, keep hand and fingers from under the clamp when clamping paper. Use Jogging Aid to load
paper, and use the backgauge to push paper out before unloading. DO NOT REACH UNDER THE KNIFE AND
CLAMP AREA!
SAFETY PRECAUTIONS
For maximum safety and to prevent unauthorized
use, turn the power switch to the off position and
disconnect the power cord whenever adjusting, lu-
bricating, or making repairs to the machine.
CAUTION: POWER LOCK-OUT PROCEDURE
(fig. 1)
This safety symbol means CAUTION/WARNING - PERSONAL SAFETY INSTRUCTION. Read the
instructions because it has to do with safety. Failure to comply with the following instructions
may result in personal injury.
NOTICE: UNSUPPORTED PRODUCT!
NO TECHNICAL SUPPORT AVAILABLE!
NO REPAIR PARTS AVAILABLE!
