17
F.200/TITAN 200/MAR 97
CAUTION: Always remove the
jogging aid from the table before
making a cut.
(fig. 20)
(fig. 21)
To make the cut, close the front guard and press the
cut button. If the guard is raised at any time during the
cut cycle, the knife and clamp will immediately return
to the up position.
Note: The guard must be opened and closed each
time a new cut is made. The cut button will light up to
indicate that the machine is ready to make a cut.
Jogging Aid
A jogging aid is included as standard equipment with
the Titan 200. This tool allows the operator to load and
align paper without the need to place hands or arms
under the knife or clamp.
To use, load the paper against the side and backgauge
using the jogging aid (fig’s. 20 & 21). Remove the
jogging aid from the table, close the guard, and make
the cut.
Knife Change Alarm and Lubrication Alarm
Titan 200 has two built in alarms that will be displayed
after a certain number of cuts. The knife alarm displays
a message to remind the operator to change the knife.
The lube alarm displays a message to remind the
operator to have the machine lubricated. The lube
alarm will also display the name and phone number of
the Challenge dealer from which the machine was
purchased. To reset either alarm, or to change the
knife alarm value, see the “Operating Controls/
Maintenance Mode/Parameters/ Knife Count” section
(pg. 20). The lube alarm value is factory set at 2,500
cuts and cannot be changed.
Manual Clamping (Using the Foot Treadle)
The Titan 200 is equipped with a manual clamping
feature which allows the operator to manually clamp
paper before beginning the cut cycle. To use this
feature, press down on the foot treadle until the clamp
comes down on the paper. While holding the foot
treadle down, close the guard and press the cut button.
Release the foot treadle once the cut has been
completed.
NOTICE: UNSUPPORTED PRODUCT!
NO TECHNICAL SUPPORT AVAILABLE!
NO REPAIR PARTS AVAILABLE!
