F.200/TITAN 200/MAR 97
18
DEFINITION OF KEYS
Variable Speed Pinpoint Backgauge Control
The backgauge control is used to manually position the
backgauge. The speed of the backgauge will depend
upon where the actuator is pressed. Press farther from
center for a faster speed. Press toward the operator for
forward direction and away from the operator for reverse
direction.
IN/MM Key
This key toggles the display to show the position and
programmed send values in inches (e.g. 5.250), inch
fractions to the nearest 1/64” (e.g. 5_
1
/
4
), or millimeters
(e.g. 133.3).
SEND Key
The SEND key is used to send the backgauge to any
valid position. If an attempt is made to send the
backgauge to an illegal position, an error message will
be displayed at the bottom of the screen stating
“Number outside limit”. In the Job mode, the SEND
key will also advance the backgauge to the next
sequential cut position before performing the cut.
Push-Out Key
The push-out key will move the backgauge forward 5
inches (or to the most forward position) and then return
it to its previous position. This allows paper to be
removed from the cutter without putting hands under
the knife and clamp.
Clear Key
The CLEAR key is used to clear error messages and
the current entry line.
Enter Key
The ENTER key selects items in the maintenance mode
and processes data that has been entered in the other
modes.
CAUTION! Never place hands in the
clamp and knife area. Use the push-
out key or the backgauge glide
control to move the paper to an area where it
can be reached.
Cut Button
SEND Key
IN/MM Key
Soft Keys
Push-Out Key
Arrow Keys
CLEAR Key
ENTER Key
Priority Add (X/Y) Key
Display
TITAN 200 DISPLAY PANEL
(fig. 22)
Variable Speed
Pinpoint Backgauge
Control
NOTICE: UNSUPPORTED PRODUCT!
NO TECHNICAL SUPPORT AVAILABLE!
NO REPAIR PARTS AVAILABLE!
