13
F.200/TITAN 200/MAR 97
It is the customer’s responsibility to provide a properly
grounded receptacle that meets the power requirements
specified on the name plate of this machine, as well as
all local electrical codes. Have a qualified electrician
install one if your location is not so equipped.
Connect the power cord into a grounded, 3-prong
receptacle only! (Recommended receptacle: 120volt,
NEMA 5-20R. 208-230volt, NEMA 6-15R, or NEMA 6-
20R.
Knife Installation/Changing
The knife changing equipment shown in fig. 12 is included
in the cutter tool kit. The following instructions show
how to remove and install a new or resharpened knife.
Read through these instructions AT LEAST ONCE before
attempting to actually change or install any blades.
Knife Removal
1. Make sure the knife and clamp are in the “up” position.
Turn the main power switch to the “OFF” position and
disconnect the machine power cord to prevent accidental
power-up while servicing the cutter.
2. Back off the knife adjusting screws on top of the knife
bar several turns (fig. 13). A new knife will cut deeper
than one that has been ground several times. Failure to
back off the screws could damage the knife and/or the
cutting stick.
3. Remove the knife bolts from the two slotted knife bar
holes and replace with the knife lifters (fig. 14). Tighten
the lifters to hold the knife in place, then remove the
remaining knife bolts.
4. Clear the table surfaces and place the empty knife
scabbard on the table. Remove the scabbard’s knife
Knife Adjusting Screws
(fig. 13)
(fig. 14)
(fig. 12)
5/16”
T-Wrench
Knife Lifters
Cut Stick
Removal Tool
3/16”
Hex Allen
Wrench
CAUTION: Changing knives can be
very dangerous unless safety
precautions are observed and
extreme care is taken when handling knives.
•
Make sure knife lifters are properly
installed, see instructions following.
•
Keep handling of unprotected knives to an
absolute minimum.
•
Clear off cutter table before removing
knife.
•
Have scabbard on cutter table and insert
knife immediately.
•
Warn people of any unprotected knife.
•
Knife changing is a ONE PERSON
OPERATION. Having more than one
person trying to change knives invites
accidents.
CAUTION: Knives are heavy and
always very sharp! Be sure to keep
the edge away from your body and
keep other people out of the area while
handling the blade. Severe lacerations or
dismemberment could result from careless
handling procedures.
NOTICE: UNSUPPORTED PRODUCT!
NO TECHNICAL SUPPORT AVAILABLE!
NO REPAIR PARTS AVAILABLE!
