6
3. Instruction manual
3.1. To start a vehicle
Turn OFF ignition before using the Booster.
The tension selector must be disconnected ! **
How to connect your Booster
-> Read point 3.3.: inversion of polarity
A. Starting in 12V
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the blue
clamp (-) to the negative (-) terminal of the battery.
B. Starting in 24V
-> Read point 3.2.: detection of 24V
n
If the batteries are side by side
:
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the
blue clamp (-) to the negative (-) terminal of the other battery.
n
If the batteries are on both sides of the vehicle
:
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the
blue clamp (-) to the mass of the vehicle.
Selection of the tension
First, check the voltage of the vehicle that has to be started -> to do so:
n
use the detection LED’s
-> Read point 3.4.: voltage detection system !!!
n
in doubt, please refer to the vehicle’s instruction manual.
Plug in the selector in the correct connector
**
-> from this moment there is current on
the clamps.
Start the engine
-> Read point 3.5. & 3.6.
Turn the ignition key for a maximum of 8-10 seconds, wait for a further 3 minutes before
attempting to start again.
Disconnection of the tension
After starting, disconnect the tension selector.
Disconnection
Disconnect the blue (-) clamp first, followed by the red (+) clamp.
Storing
-> Read point 3.7.
Return the cables and clamps to their support posts.
Recharging
After use, put the Booster immediately back in its docking station !
** Important !!!
-> See point 4.2. (point 5.) : Explosion risk
1.
2.
3.
n
n
4.
5.
6.
7.
8.
