Installation Guide for FibeAir IP-20F
Page 46 of 63
Ceragon Proprietary and Confidential
2 Click
Browse
, and select the configuration file for your unit.
Figure 15: Quick Configuration
–
From File Page
–
Configuration File Loaded
3 In the
Device List
field, select the IP-20 unit you are configuring.
4 Optionally, click
View file
to display the configuration file (read-only).
5 To initiate the configuration, click
Submit
. Progress is updated in the Quick
Configuration
–
From File page.
When the configuration is complete, the unit reboots.
If the configuration file includes changing from ETSI to ANSI mode, the unit reboots at
that point in the configuration. After the reboot, you must return to the Quick
Configuration
–
From File page and re-initiate the configuration.
Note:
If the pre-defined configuration file included a new IP address for
the unit, make sure to configure an IP address on the PC or laptop
you are using to perform the configuration within the same subnet
as the IP-
20 unit’s new IP address
.
