FibeAir® IP-20E
Installation Guide
Ceragon Proprietary and Confidential
Page 22 of 52
5 Screw the gland into the radio unit until there is full contact between the
gland and the radio unit.
Important Note!
Before tightening the gland, make sure the gland is aligned
with the taped hole in the unit. Tightening the gland at an
angle can ruin the thread on the gland and prevent proper
sealing of the interface.
Tighten the gland gently and make sure there is no
resistance. If there is resistance, stop immediately, and
thread out the gland. Verify that the gland thread is not
damaged and tighten the gland again.
If the gland thread is damaged do not use it!
6 Tighten the gland cap.
Important Note! Pay attention that the gland rubber is properly located
and not damaged during the tightening of the gland cap.
7 Secure the cable to the gland using a tie wrap.
