Century Heating CB00023, Инструкция по установке и эксплуатации

Страница: 8 / 56

Page 8 Installation and Operation Manual - FW3200
ENGLISH
2. General Information
2.1 Performances
Values are as measured per test method, except for the recommended heating area, firebox volume,
maximum burn time and maximum heat output.
Model FW3200 (CB00023)
Combustion Technology Non catalytic
Fuel Type Dry Cordwood
Recommended heating area (sq. ft.
.
)
1
900 to 2,300 ft
2
(83.6 to 213.7 m
2
)
Nominal firebox volume 3.3 ft
3
(0.093 m
3
)
EPA loading volume 2.67 pi
3
(0.056 m
3
)
Maximum burn time
1
10 hours
Maximum heat output (dry cordwood)
2
90,000 BTU/h (26.4 kW)
Overall heat output rate (min. to max.)
2 3
15,841 BTU/h to 57,041 BTU/h
(4.64 kW to 16.72 kW)
Average overall efficiency
3
Dry cordwood
71.1 % (HHV)
4
76.6 % (LHV)
5
Optimum efficiency
6
78 %
Average particulate emissions rate
7
0.95 g/h (EPA / CSA B415.1-10)
8
Average CO
9
61.3 g/h
1
Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type
and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum
acceptable temperature in the designated area in case of a power failure.
2 The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft 3 and 20 lb/ft 3 . Other performances are based on
a fuel load prescribed by the standard. The specified loading density varies between 7 lb/ft³ and 12 lb/ft
3
. The moisture content is between 19%
and 25%.
3
As measured per CSA B415.1-10 stack loss method.
4 Higher Heating Value of the fuel.
5
Lower Heating Value of the fuel.
6 Optimum overall efficiency at a specific burn rate (LHV).
7
This appliance is officially tested and certified by an independent agency.
8 Tested and certified in compliance with CFR 40 part 60, subpart AAA, section 60.534(a)(1(ii) and draft ASTM WK47329-14
9
Carbon monoxide.