SKU 47077 For technical questions, please call 1-800-444-3353.
Page 6
1/4”-18 NPT
MALE QUICK CONNECTOR
(NOT PROVIDED)
THROTTLE
LEVER
SAFETY
LOCK
(#7)
SPINDLE
(#32)
FLANGE
(#34)
AIR INLET
BUSHING (#1)
3” CUTTING DISC
(not included)
HEX
BOLT
(#35)
FIGURE B
2.
Insert the 3” cutting disc (not included) onto the Spindle (32). Then, use the
Spanner (36) to hold the Spindle in place. Next, insert the Hex Bolt (35) through
the Flange (34), through the 3” cutting disc, and back into the Spindle. Secure
the 3” cutting disc to the Spindle by tightening the Hex Bolt into the Spindle with
the Hex Key Wrench (37).
(See Figure B, and Assy. Diagram.)
OPERATING INSTRUCTIONS
1.
Set the air compressor’s regulator to 90 PSI.
Caution:
Do not exceed 90 PSI.
2.
Connect the Air Cutter to the air compressor hose.
3.
Secure the workpiece you are cutting in a vise. The workpiece must be secured
so that it cannot move while you are performing the work.
4.
Mark the workpiece area where you wish to cut.
5.
With both hands, grip the Air Cutter so that your thumbs rest on the Throttle Lever
(3) and Safety Stick (7).
(See Figure B, and Assy. Diagram.)
6.
Make sure the 3” cutting disc is not touching the surface of the workpiece.
(See
Figure B, and Assy. Diagram.)
(#3)
PROTECTION
GUARD (#30)
