SKU 47077 For technical questions, please call 1-800-444-3353.
Page 3
7.
DO NOT OVERREACH.
Keep proper footing and balance at all times to prevent
tripping, falling, back injury, etcetera.
8.
INDUSTRIAL APPLICATIONS MUST FOLLOW OSHA REQUIREMENTS.
9.
STAY ALERT.
Watch what you are doing at all times. Use common sense. Do
not use this product when you are tired of distracted from the job at hand.
10.
CHECK FOR DAMAGED PARTS.
Before using this product, carefully check that
it will operate properly and perform its intended function. Check for damaged
parts and any other conditions that may affect the operation of this product. Re-
place or repair damaged or worn parts immediately.
11.
REPLACEMENT PARTS AND ACCESSORIES:
When servicing, use only identi-
cal replacement parts. Only use accessories intended for use with this product.
Approved accessories are available from Harbor Freight Tools.
12.
MAINTAIN THIS PRODUCT WITH CARE.
Keep this product clean and dry for
better and safer performance.
13.
MAINTENANCE:
For your safety, service and maintenance should be performed
regularly by a qualified technician.
14.
USE THE RIGHT PRODUCT FOR THE RIGHT JOB.
There are certain applica-
tions for which this product was designed. Do not use small equipment, tools, or
attachments to do the work of larger industrial equipment, tools, or attachments.
Do not use this product for a purpose for which it was not intended.
15.
WARNING:
The warnings, precautions, and instructions discussed in this manu-
al cannot cover all possible conditions and situations that may occur. The opera-
tor must understand that common sense and caution are factors, which cannot
be built into this product, but must be supplied by the operator.
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1.
USE CLEAN, DRY, REGULATED COMPRESSED AIR AT NO MORE THAN 90
PSI.
Never use oxygen, carbon dioxide, combustible gases, or any other bottled
gas as a power source for this tool.
2.
NOTE:
An air compressor is not provided. You will need an air compressor with a
minimum rating of one horsepower, 5.5 SCFM delivery at 90 PSI, and a 12 gallon
air tank.
3.
WHEN CONNECTING TO THE AIR SUPPLY:
Prior to each use, if an automatic
oiler is not used, add two drops of air tool oil (not provided) into the Inlet Bush-
ing (1) of the Air Cutter. Turn on the air compressor, and set the regulator to the
recommended 90 PSI for this tool.
(See Figures A, B, and Assy. Diagram.)