SKU 47077 For technical questions, please call 1-800-444-3353.
Page 7
7.
Press the Safety Lock (7) forward as you press down on the Throttle Lever (3).
NOTE:
The Air Cutter’s speed is variable. Vary the pressure placed on the Throt-
tle Lever to vary the speed of the tool. Use only enough speed as needed to cut
the workpiece.
(See Figure B, and Assy. Diagram.)
8.
Slowly and carefully place the edge of the 3” cutting disc onto the surface of the
workpiece.
(See Figure B, and Assy. Diagram.)
9.
Keep a steady pressure on the Air Cutter. But do not force the tool, as you will
stall the Air Cutter. Use only enough pressure to do the job properly.
10.
When you are finished with the job at hand, release all pressure on the Throttle
Lever (3) to stop the tool.
(See Figure B, and Assy. Diagram.)
INSPECTION, MAINTENANCE, AND CLEANING
1.
CAUTION:
Always disconnect the Air Cutter from its compressed air supply
source before performing any inspection, maintenance, or cleaning.
2.
BEFORE EACH USE,
inspect the general condition of the Air Cutter. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
dull or damaged Cutting Disc, damaged air supply hose, and any other condi-
tion that may affect the safe operation of this tool. If abnormal noise or vibration
occurs, immediately disconnect the Air Cutter from its compressed air supply
source and have the problem corrected before further use.
Do not use damaged equipment.
3.
PERIODICALLY,
use a premium quality, lightweight oil to lubricate all moving
parts.
4.
WHEN NECESSARY,
wipe with a damp cloth, using a mild detergent or mild sol-
vent.
5.
WHEN STORING,
keep the Air Cutter in a box or covered with a clean cloth.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY
REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.
IN FACT, THE MANUFACTUER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
