SKU 47077 For technical questions, please call 1-800-444-3353.
Page 5
UNPACKING
When unpacking, check to make sure all the parts shown on the
Parts List
(page 8) are
included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE:
For additional references to the parts listed below, refer to the
Assembly
Diagram on page 8.
To Connect An Air Hose To The Air Cutter:
The Air Cutter requires the attachment of a 1/4”-18 NPT Male Quick Connector
(not provided). To attach a Quick Connector to the Air Cutter, wrap the threaded
portion of the Quick Connector with about 3” of pipe thread seal tape (not
provided). Next, wrench tighten the Quick Connector into the Inlet Bushing (1) of
the Air Cutter. Then, connect the Quick Coupler of an air hose (not
provided) onto the Quick Connector.
(See Figures A, B, and Assy. Diagram.)
To Attach The 3” Cutting Disc:
1.
Use the Spanner (36) to hold the Spindle (32) in place while, at the same time,
loosening and removing the Hex Bolt (35) and Flange (34) with the Hex Key
Wrench (37).
(See Figure B, and Assy. Diagram.)
11.
DO NOT REMOVE THE PROTECTION GUARD (30).
Always leave the Protec-
tion Guard in place. Never use the Air Cutter without the Protection Guard in
place and in proper working condition.
12.
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities, contain chemicals known (to the State of California)
to cause cancer, birth defects or other reproductive harm. Some examples of
these chemicals are: lead from lead-based paints, crystalline silica from bricks
and cement or other masonry products, arsenic and chromium from chemically
treated lumber. Your risk from these exposures varies, depending on how often
you do this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such as those
dust masks that are specially designed to filter out microscopic particles.
The brass components of this product contain lead, a chemical known to the
State of California to cause birth defects (or other reproductive harm).
(California Health & Safety Code § 25249.5,
et seq.
)
REV 04i; 07a