SKU 94652
For technical questions, please call 1-800-444-3353
PAGE 11
3.
Finger tighten four Hex Bolts (71), with four Serrated Lock Washers (68), up-
ward through the four mounting holes in the two Supports (128) and into the four
threaded mounting holes in the Table (6).
(See Figure D.)
4.
Loosen the Clamping Handle (133). Turn the Table (6) to the 0 position as indi-
cated on the Pointer (129). Then tighten the Clamping Handle.
(See Figure E.)
5.
Place a T-Square (not included) on the Table (6), aligning it with the front groove
on the Table and the Saw Blade (35). Align the Table, then tighten the two Hex
Bolts (71), with their Serrated Lock Washers (68)
(See Figures F and D.)
6.
Loosen the Clamping Handle (133). Then tighten the two Hex Bolts (71), with
their Serrated Lock Washers (68)
(See Figures E and D.)
7.
Loosen the Clamping Handle (133). Next, loosen the Hex Bolt (123) on the
Stopper (124). Use the Hex Bolt to align the Table (6) in a right angle with the
Saw Blade (35). Then, retighten the Hex Bolt.
(See Figures E and G.)
FIGURE D
FIGURE E
FIGURE F
FIGURE G
HEX BOLT
(123)
STOPPER
(124)
T-SQUARE
(NOT INCLUDED)
CLAMPING HANDLE
(133)
POINTER
(129)
HEX BOLT
(71)
SERRATED LOCK WASHER
(68)
SAW BLADE
(35)
