Reference
12
FIG. 4
ENGLISH
6
69
FIG. 12a
FIG. 12b
13
FIG. 3
FIG. 11
Support trolley
Chariot support
Stützwagen
Carro de soporte
Carrello di supporto
To assemble the socket (Ref. to Fig. 7 page 67):
1
Slide the socket onto the square shaft (08) lining up the bores of the socket and the
shaft (Ref. to Fig. 7a).
2
Fully insert the central split pin of
“CLIP-NR”
into the through bore, ensuring the sprung
arms are correctly located in the slot around the socket (Ref. to Fig. 7b).
To disassemble the socket, extract
“CLIP-NR”
by simultaneous lateral pushing on both
ends of the sprung arms (Ref. to Fig. 7c).
Keep the
“CLIP-NR”
in a safe place to avoid loss or damage.
Any accessory (extension, adapter, joint, socket) must be specified for use
with impact tools.
The use of unsuitable accessories could lead to breakage.
3.3) Torque adjustment
(Ref. to Fig. 3)
The wrench is equipped with a system which allows torque
limitation on tightening and loosening.
For particular requirements it is possible to vary the torque
by means of a 5 position selector (13).
To select torque values, simply turn the selector in one
direction or the other.
Usually selector (13) is set:
–
in the tightening phase
on low torque settings,
pos. 1 - 2 - 3.
–
in the loosening phase
on high torque settings,
pos. 3 - 4 - 5.
3.4) Setting the rotation direction
(Ref. to Fig. 4)
The rotation direction of the shaft is set using the 3 position
selector (12):
: right sense of rotation, to tighten.
: idle position (main shaft gears disengaged).
: left sense of rotation, to loosen.
WARNING: adjustment of selector (12) must always be carried out with the engine
switched off or idling to ensure correct engagement of gears.
Once a rotation direction has been set, the rotation of the square shaft will be achieved
only by increasing the revs of the engine consequent to automatic intervention of the
centrifugal clutch.
3.5) Operation
With the impact wrench placed on the ground on a flat surface, carry out the following in
the order shown:
– Add fuel mixture to the tank (see
§ 4
).
– Choose the socket appropriate to the work to be carried out and assemble it on the
square shaft (see
§ 3.2
).
KHOR-NR
