CE Labs MP70, Инструкция по эксплуатации, Страница: 26 / 48

24
Many of the control functions are
accessible via network control. In
order to determine the IP Address of
the unit, press MENU on the Remote
Control while pointing at the IR input
on the front of the unit. Press the
down arrow key and then ENTER on
INFORMATION. If you need the unit
to be on a different address, it may be
changed in the NETWORK SETTINGS
menu as shown below. The Network
Settings are accessed through the
Player Setup menu.
In most installations, it is best to use
DHCP and let the local router assign
an IP address to the media player.
The unit may be given a permanent
fi xed address by un-checking the
USE DHCP box on this screen and
updating the IP ADDRESS, MASK,
and GATEWAY fi elds.
You must highlight Save Changes and
press ENTER on the remote control for
these settings to be remembered once
you exit this screen.
Warning: Verify that there are no other
devices on your subnet with this IP Address.
Two devices with the same address will cause
erratic behavior.
To adjust the appearance of the
video on the monitor, navigate to the
Player Setup menu, and press VIDEO
SETTINGS.
Move the highlight curser to the
parameter to adjust and use the right
or left arrow on the remote to change
the value. Watch the monitor to see if
the change is acceptable.
The Color Profi le adjustment allows you to choose from preset video confi gurations
that were derived from typical brands of monitors. The size controls allow you
to customize the picture size to fi t the video monitor. These settings are saved
automatically. Press the MENU button to exit this screen.