CE Labs MP70, Инструкция по эксплуатации

Страница: 12 / 48

10
The MP70 is capable of driving a wide variety of displays at up to 1080P
resolution at bit rates up to 40 Mbps (mpeg2 file type). Depending upon
your application, connect the following cables to operate the unit.
• Display cable – The MP70 supports full 1080p video resolution via
HDMI output.
Note : Video output resolution has been pre-set at the factory for 1080p
(in most applications).
• Power – The MP70 uses a 12VDC, 2A power supply. Total power
consumption is approximately 7 Watts which leaves a large
reserve in the power supply. Insert the power supply 12 VDC
plug into the MP70 power jack. Insert the AC Plug of the
power supply into an electrical outlet. The power LED should
now be illuminated.
• Ethernet – If this is a networked installation, connect the Ethernet Port
to a Switch or Router via an Ethernet cable. The unit will
automatically obtain an IP address as long as the unit’s DHCP
is selected as ON and there is a DHCP server somewhere on
the local subnet.
Please wait for approximately 1 1/2 minutes until the unit
completes the boot-up process. The media player can be configured
to have a default start-up item such as a video file or a playlist. If the
default startup item has been configured, video should start playing
automatically when the unit has completed its boot-up process.
• IR Remote – The IR remote is used to access the unit’s On Screen
Display menu and perform basic unit controls such as
setting volume and setting network parameters. If you
need to determine the IP address for the unit, go to the
network settings window. Please store the remote in a
safe location for possible later use.
• IR Eye – There is an internal IR receiver on the front of the unit. Point
the IR remote at this target when accessing the OSD menu.
Connections