28
Turning Signal Lamp
1. Remove two screws on the lamp shade
and remove the lamp shade.
2. Press down the bulb and left turn it and
remove the bulb.
3. Press the newly installing bulb down and
right turn it when installing the new lamp.
Caution:
Pay attention not to excessively tighten two
screws for preventing the lamp shade from
crushing after installing the lamp shade.
Tailing Lamp / Braking Lamp
Replace the bulb of tailing lamp / braking lamp
according to the following instructions:
1. Remove two screws on the tailing lamp
shade and then remove the lamp shade.
2. Press down the bulb and left turn to
disengage the pin. Pull the bulb out. Push
the bulb and right turn to tighten the bulb
when installing.
Caution;
Don’t excessively tighten the fixing screws
when re - assembly the lamp shade.
Air Filter
The air filter of this motorcycle is made of foam
plastic. If the air filter element is clogged by dust
and with power output is decreasing, the air inlet
resistance will be increasing. With gasoline
content in the mixing gas is increasing, fuel
consumption will be increasing. Therefore, after
every driving 3000km, examine and clean the air
filter element according to the following
procedures.
Caution:
Frequently clean or replace the air filter when
driving under dusty condition.
1. Remove the left guard plate.
2. Loosen closure screw
○
1
of air filter and
remove the air filter sleeve
○
2
.
3. Take out the foam plastic sleeve housing of
the air filter.
4. Separate the foam plastic and the external
frame.
5. Carburetor
Carburetor stability is a foundation to ensure
engine performance. The carburetor has been
adjusted in an optimized way in the factory
before delivery. Don’t unnecessarily adjust it.
Please note that accelerator steel wire clearance
and idle speed need to be adjusted for the
carburetor. Adjust it after initial driving 1000km
or every 3000km according to the following
procedures.
Idle Speed RPM Adjustment of Carburetor
