C
OMPONENT
M
AINTENANCE
M
ANUAL
S
OAP
D
ISPENSERS
S
EIFENSPENDER
B82X
S
ERIES
No.: 25-40-01
Issue: D
Date: May 02/2022
25-40-01
May 02/2022
1 Shank can be shortened up to max. 90 mm
(3.54 in.), it is recommended to cut the shank in
the unthreaded section (65 mm (2.56 in.)).
NOTE:
Examine that the surface of cut is plane.
(b)
Unit PN B823 Series (Ref. IPL, Fig. 1E, 1F, 1G and 1H)
NOTE:
If you discard the PVC-tube and lower part
of the shank and if you screw the adapter
to upper part of the shank B823 is modified
to B822 with the shortened shank.
1 Tube can be shortened (original length 900 mm (35.4 in.)).
NOTE:
If the unit is modified, the PVC-tube (20)
must be replaced and notched at the end.
C.
Procedure
(1)
Installation of Unit PN B822 Series (Ref. Fig. 13001)
WARNING: IN ORDER TO GUARANTEE MAXIMUM PERFORMENCE OF LIQUID
SOAP DISPENSER LIQUID SOAP MUST HAVE A VISCOSITY
< 30 MPA/S, NACL-SHARE < 1 % AND BE FREE OF ALCOHOL
AND AROMATIC COMPOUNDS. WE RECOMMEND TO USE ONLY THE
ORIGINAL SOAP APPROVED BY CBS - CARSTEN DAUS GMBH.
(a)
Install metal washer and rubber washer onto shank.
(b)
Insert piston assy together with shank into the
mounting hole of the cabinet.
NOTE:
Ensure that the outlet of the piston extends
over the sink and that it remains in position
during
further
installation.
If
shank
is
to
be
installed
without
piston
and
spout,
ensure
that the spring in the lock is lined up
with
the
expected
outlet
direction.
(c)
Install tooth lock washer and retaining nut onto
shank.
CAUTION:
TO PREVENT DAMAGE TO SHANK ASSY, DURING
FASTENING RETAINING NUT, USE NOT TOO MUCH
POWER.
TORQUE
VALUE
IS
15,00
NM
(11.06
lb.ft.).
(d)
Tighten up retaining nut hand tight.
(e)
Install soap container with adapter onto shank.
NOTE:
Apply sealant (Elastosil E43) for the soap
container
installation.
PAGE 13002