C.B.M. S.r.l. a socio unico - Medical Equipment –
Via Castello 10, 26038 Torre dé Picenardi (CR) - Italy
Rev. 06 – 18/02/2019
Manuale SST1700-2200 r06 CE-1282 EN
page 30 of 34
PAPER REPLACEMENT
1) Pull the cover lever (3)
WARNING:
do not use excessive force to avoid damaging the lever.
2) Introduce the paper roll with the lead edge in the lower area.
3) Pull the paper lead edge out of the printer for about 3 cm.
4) Close the cover by pressing on the centre near the paper output, or on both top sides of
the cover simultaneously.
WARNING:
Do not press on one side only.
5) Press the
>>
key to feed more paper (if needed)
6) To cut the paper at the end of a cycle, take one edge and pull carefully downwards.
7) To take out the finished roll proceed as per point 1)
DESCRIPTION AND USE OF THE KEYS AND LEDs:
LED
ON
Flashing
Flashes 3
times
Flashes 4 times
Printer ON
Printer OFF
NO paper
Wrong temperature
(too high or too low)
KEYS
II
Pressed Once switches the printer
ON or OFF
With the printer ON, if pressed for
more than 3 seconds performs the
printer test
>>
When pressed feeds and expels
the paper
TROUBLESHOOTING
PROBLEM
POTENTIAL CAUSE
REMEDY
Does not print
- No paper
- Printer OFF
- Printer not selected
- Paper roll in wrong position
- Unsuitable paper
- temperature too high or too low
- Introduce a new roll
- Switch printer ON
- Select the printer
- Reposition the roll
- Check that the paper is for thermal
printing
- Wait for the appliance to cool down or
warm up
