18
- "R" (REMOTE SWITCH): the device is controlled by a remote ON-OFF switch (see the connection in "Figure 2").
- With each short press, the Wi-Fi is switched on/off.
- "1" (ON): the device is on.
- "0" (OFF): the device is off (both batteries are not connected to the system).
2)
"RESET" button.
1)
Three-position selector switch:
To press the button, insert a sharp object (e.g. a screwdriver) into the hole and press lightly.
3)
Blue Wi-Fi status LED.
ATTENTION:
9)
Faston type "6.3" to connect the earth cable of the BDS180.
LED ON: battery connected to the system.
5)
Yellow service battery "2" operation status LED:
LED BLINKING (LONG BLINKS): faulty battery.
The remote switch connector can be used to connect a switch in order to turn ON or OFF the device from a remote point,
for cases in which BDS180 is installed in a position that is difficult to reach.
10)
"M6" bolt for the connection of the positive pole of service battery "1".
11)
"M6"
(users, battery charger, solar charge
,...).
bolt for the connection of the 12V system
regulator
LED BLINKING (SHORT BLINKS): "BATTERY
" on.
PROTECTION
8)
REMOTE SWITCH connector; the device can be turned on remotely.
12)
"M6" bolt for the connection of the positive pole of service battery "2".
In the presence of the remote switch, the BDS180 selector must be set on the “R” position.
LED BLINKING (SHORT BLINKS): "BATTERY
" on.
PROTECTION
LED BLINKING (LONG BLINKS): faulty battery.
When the Wi-Fi is on, the LED blinks twice every 2 seconds (short blinks).
-Press and hold the button for at least 3 seconds to reset the Wi-Fi connection password (to set a new password, go to
the “PASSWORD RESET” menu).
4)
Yellow service battery "1" operation status LED:
LED ON: battery connected to the system.
6)
CBE BUS system connector (optional).
7)
"MC180" remote panel connector.
In the absence of the remote switch, the “R” position of the BDS180 selector must not be used.
10
11
12
8
7
6
9
4
5
1
3
2
figure 1
LEGEND
EN
