16
The batteries work in optimal conditions (separately and alternately) providing the maximum
available capacity to the system while extending their own life.The efficiency of each individual
battery is tested during operation.
BDS180 is an electronic device with built-in microprocessor able to control two 12V batteries during charge and discharge,
allowing to use batteries of equal or different capacities and even of different ages.
AUTOMATIC MODE: the device manages
battery use according to their state of charge.
the
The “manual” mode can be enabled from the “MC180” remote panel (optional) or from your mobile device via the “CBE
Remote Control BDS180” APP (available on “APP Store ”).
s
The device can be used in
or in
mode.
“manual”
“automatic”
MANUAL MODE: the
battery is connected permanently, disabling any type of automation and control (except
for the “battery
” function).
selected
protection
RULES OF INSTALLATION AND USE
The device must be used only for the management of
service batteries.
Any direct connection to the batteries may cause the device
to malfunction.
The BDS180 should only be used with lead-acid, lead-gel
AGM
or
.
NB:
The device is not compatible with nickel/cadmium
batteries lithium-ion batteries or other type of
rechargeable or non-rechargeable batteries.
,
The device cannot be used outdoors and must be installed
in a dry, well-ventilated compartment.
Use cables of appropriate cross-section (size).
Protect cables from damage. Install a protective fuse for
each battery in its immediate vicinity.
Before connecting the device, check that the switch
installed on it is in the “0" position (off).
GENERAL INFORMATION
AUTOMATIC SELECTOR FOR TWO
SERVICE BATTERIES “BDS180"
IMPORTANT:
-
Installation shall be performed by qualified technical personnel.
-
In case of improper use of the device, the warranty shall be void and the manufacturer declines all
responsibility for damage to persons or property.
-
Waste batteries shall be disposed of in compliance with current environmental protection standards.
-
The selector can be used with two batteries of different capacities, provided that they use
the same technology, for example two gel batteries.
(Never connect, for example, a lead acid battery and a lead gel battery!).
EN
