CB Svendsen FA-20, Руководство пользователя

Страница: 15 / 26

15
Kamstrup Multical III, 66C, Compact, 401, 601 with “data base” (KMX driver):
-
The Multical meter must have ”3-wire data base”
mounted.
-
Three wires needs to be connected (Called GND, REQ
and DATA) to Multical.
-
If Multical 601 has ”compatibility module” mounted KMX is
to be used otherwise use the KM6 driver.
-
It is only ”Multi”, which can be interfaced using the KMX
driver.
-
Data base is significantly cheaper than the M-bus to Multical.
Kamstrup Multical 601 and 801 with “data base”
(KM6 driver):
-
The Multical meter must have ”data base” mounted.
-
Three wires needs to be connected (called GND, REQ and
DATA) to 601/801.
-
Multical 601 ”data base” is also obtainable as a top
module.
-
It is only ”Multical which can be interfaced using the KM6 driver.
-
Data base is significantly cheaper than the M-bus to Multical.
Kamstrup Unigas 61E (Unigas 61E driver):
-
In Unigas three wires must be connected to the white plug on the
motherboard (NOT to the plug in the lid). Green wire (“Data” pin 1
in Unigas) is connected to terminal 12 in FA-20. White wire (“Gnd”,
pin 3 in Unigas) is connected to terminal 10 in FA-20. Brown wire
(“Reg”, pin 5 in Unigas) is connected to terminal 11 in FA-20. It is
recommended to connect FA-20 directly to the internal plug in
Unigas and let the plug with the RPG-connectors be connected to the communications
print in the lid of Unigas. Hereby can Unigas be tapped on location without opening the lid
on the Unigas and communication between Unigas and FA-20 can not be interrupted by
removing the plug by the RPG-connectors.
Connecting the following meters with M-bus to”Multi”:
(Note: polarity of the M-bus connection is without significance)
AquaMetro : AquaMetro with M-bus.
Brunata HG : HGR, HGP, HGQ and HG754.
Elster
: Mecanical gas meter with M-bus
Kamstrup : Multical III / 66C with M-bus.
Multical 401 / 601 / 801 with M-bus.
(Note.: It is cheaper to use 3-wire data
module for Multical then M-bus module).
Kamstrup
:Var. Power and water meters with M-bus.
L&G : WSD and WSF.
L+G : 2WR4, 2WR5 and UH50
Sensus : Mechanical water meter with M-bus.
Skovgaard : Sharkey with M-bus and Infocal 5 with M-bus.
ABB
: Var. Power meters with M-bus.
Special case:
UH50 with G4 M-bus can not be connected Multi, see above! The jumper between 11
and 12 is replaced by an 8 kohms resistance between terminal 3 and 11. Pulse input P2
can still be used.