411, 611 & 325 OCU
User Manual
6
9M02-8999-A001-EN
WARNING
Observe the statutory regulations and directives applicable for the intended purpose, e.g.:
•
Accident prevention regulations
•
Safety rules and directives
•
Standards
•
Generally applicable statutory and other binding regulations for accident prevention and
environmental protection, and general safety and health requirements.
•
Ensure that users have access to the user manual.
•
The personnel assigned to work on/with the product must have read and understood this operating
manual and the safety instructions.
•
The safety instructions must, if necessary, be supplemented by the user with instructions concerning the
work organization, work sequences, qualified personnel, etc.
•
All repairs made during the warranty period must be carried out by the manufacturer or appointed
authorized service center; failure to comply will invalidate the warranty.
•
All repairs made should be carried out in a suitably clean static-safe environment, free from contaminants
such as metal filings, water, oil, etc.
•
It is the user’s responsibility to ensure that the product always operates in good condition and that all
applicable safety requirements and regulations are observed.
•
Product modifications may not be carried out without the consent of the manufacturer.
•
Original spare parts from the manufacturer must be used.
•
Carry out periodic inspections and/or maintenance either required by law or prescribed in the user manual
within the required intervals.
2.3 Improper Use
Ensure compliance with equipment ratings and operate only as intended, in particular:
•
Ensure all supplies to the equipment are isolated before installation/maintenance
•
Check that power supply voltage / frequency data is correct
•
Do not misuse or exceed operating specifications
•
Ensure periodic maintenance routines are observed
CAUTION
Damage to the device:
The unit is rated at IP67. For environments harsher than this, use an appropriate secondary
enclosure.
Neglecting the above can result in danger for life and limb and/or cause physical damage to the
product or the environment.
2.4 Safety Instructions for Assembly / Disassembly
Note:
Ensure suitable transient protection devices are fitted to controlled electrical relays or valves. Ensure
correct wiring of the cr
ane’s main contactor and the manual radio transfer switch.
!
!
