ENGLISH June 2021 IND B
Page
32
of
156
CATANA SAS - Zone Technique du Port - 66140 CANET EN ROUSSILLON (FRANCE)
e - mail : [email protected] - Tel 33 (0)4 68 80 13 13 - Fax 33 (0)4 68 80 13 19
6.2. Fresh water pressure pumps with tank selector tap
The galley sink and the basins in the heads are supplied with fresh water by an electric pump (Figure 7).
A filter is fitted before the pump. This must be cleaned regularly.
It is possible to sterilise the tanks using clonazone tablets (on sale in pharmacies), added via the filler neck.
When winterizing the boat, fill the tanks completely so as to avoid the growth of algae or bacteria. If there
is a risk of freezing, empty the tanks completely. Never use antifreeze.
Hot water is produced by a water heater connected to the engine cooling system and also the shore power
system.
After emptying the water heater, ensure that the immersion element is immersed again prior to switching
the power back on.
The water pump is equipped with a safety system which switches off the pump in the event of the level in
the water tanks becoming too low. The pump can be reactivated using the control button on the
touchscreen, but doing so will deactivate the safety shut-off system.
WARNING
Never activate the pump or switch on the water heater if the tanks are empty.
Refill the tanks.
If you fail to comply with this, the hot water immersion element and the pressure pump will be
irreparably damaged.
It is imperative to keep the tanks empty in the event of the temperature going below freezing .
Fresh water pump and filter are
located beneath the port aft bunk.
Figure 7
