Operator’s Manual
HPS10IC Pellet Stove
Check for parts online at
www.castlestoves.com
or call 800-345-6007 M-F 8-5 CST
9
SPECIFICATIONS
Model Number
HPS10
BTU/hour input (1)
4.0 lbs/hr
Heating Capacity (2)
1,500 sq. ft.
Electrical Rating (3)
115 Volts, 60 Hz
Power Consumption
520 Watts ignition
150 Watts operating
Fuel Storage Capacity
40 lb
Flue Size (4)
3 in.
Width
18.25 in.
Height
34 in.
Depth
23.75 in.
Weight
186 lbs.
(1) Heat output will vary, depending on the brand, type and
quality of fuel and the moisture content. Consult your dealer
for best results.
(2) Based on post 1982 home construction, requiring 35 BTU/
Hr. per Sq. Ft.
(3) Install per NFPA 70 and follow all state and local codes,
contact licensed electrical contractor for assistance.
(4) Install per NFPA 211 and follow all state and local codes,
contact licensed installers for assistance.
Listing label:
Tested to the following standards: UL1482, ASTM E1509, ULC/
ORD-C1482-M1990, and UCL S627-2000
GLASS SPECIFICATIONS
This stove is equipped with 5 mm ceramic glass. Replace glass
only with Castle Pellet Stoves ceramic glass. Call your Servic-
ing Dealer or Castle Stoves at 1-800-345-6007 for replacement
parts.
UNPACKING
Your Castle HPS10 will come fully assembled. Remove all pack-
ing material and tape from the inside of the firebox. Remove
any tape on the outside of the glass. Open the hopper, remove
all packing material and power cord.
NOTE: MAKE SURE THE HOPPER IS FREE OF ALL FOREIGN
MATTER BEFORE FILLING WITH FUEL. FOREIGN MATE-
RIAL WILL CAUSE AUGER JAMS AND WILL VOID STOVE
WARRANTY.
CAUTION
THIS INSTALLATION MUST CONFORM WITH LOCAL
CODES. IN THE ABSENCE OF LOCAL CODES YOU MUST
COMPLY WITH ASTM E1509, (UM) 84-HUD, ULC/ORD-
C-1482 AND and UCL S627-2000.
CASTLE PELLET STOVES, MANUFACTURER OF THIS
APPLIANCE, RESERVES THE RIGHT TO ALTER ITS
PRODUCTS AND/OR THEIR SPECIFICATIONS WITH-
OUT NOTICE.