V2
TB
VB1
P R
VB2
3
Fig 2
VB1
GA
TB
P R
VB1
Lining up the stops:
Pass the thread under the head of the NS against the inner face of the guide
GB. Put in one screw and two nuts at one end of the thread (looped) and
hook to the left tip of the left extension stop.
Repeat for the other end of the thread. Adjust the length of the thread so as
to create tension when it is hooked to the right tip of the NS guide. Increase
the tension in the thread by tightening the nuts with a 10mm open end
wrench.
Left hand
extension
NS
GB
fig 5
Table
Stop
Horizontal
level
Perpendicular level (base)
Proper adjustment:
1) The thread is stretched uniformly on the right and left stops.
2) There is no gap in the STOP/MACHINE joint (J).
If this is not the case, move the NS sideways until the thread is
fully stretched on the two stops and the gap in joint J disappears.
NS
J
