Cassese CS 88, Техническое и руководство пользователя

Страница: 12 / 17

9
MAINTENANCE
6mm MAXIMUM ( 1/4 ’’ )
WEDGE REMOVING TOOL
D
ISTRIBUTOR
( BLOCK H )
WEDGE E
XIT
1) LUBRICATION
Periodically, remove the wedge distributor (Fig 1, block H) and clean it (by air gun) without dis-
mounting it.
It is recommended to lubricate the hammer (driver blade) periodically. To do so, remove the
wedge distributor (block
H)
and put a small quantity of grease in the bottom hole of the wedge
distributor. The hammer will be lubricated every time it crosses the wedge distributor.
2)
CLEARING OF A WEDGE STUCK IN THE WEDGE DISTRIBUTOR
If you push the foot pedal half way and release, a wedge may be half engaged in the wedge
distributor. In this case,
- Close the air valve (CS 89).
- Try to remove the cartridge that is in position. If it resists, use the wedge removal tool to push
down the wedge back in the cartridge.
- Pay attention not to make penetrate the tool more than 6mm (¼”) into the wedge distributor.
It is important not to leave a wedge half engaged in the wedge distributor, as it may cause
the insertion of two wedges when you join the next corner or may cause the jamming of
the hammer (the driver blade) in the wedge distributor.
- In case of the hammer (driver blade) jamming with a wedge in the wedge distributor, see the
following section (3).