Page 8 of 14 EQ2006 R.1.5 Rev. 02 dated 09/11/2007
At the end of the stroke in opening of the motor 2 the state of the
leds is that represented to the left side
Hold pressed the key PS1 to start the motor 2 in closing; release the key to stop the
leaf in the point in which you desire to fix the leaf delay in closing.
WARNING! If you don’t want to plan any delay shutter in closing send a short impulse
with the key PS1 to pass over the following point
Hold pressed Hold pressed the key PS1 to plan the time of work in closing for motor
2.
WARNING! If you want to plan the final portion of the stroke in deceleration, release the
key PS1 in the point in which you desire to continue with the low speed.
If you want to effect the whole stroke with normal speed, maintain pressed PS1 and
release it just at the end of the closing (when limit switch is working FCC 2).
Hold pressed the key PS1 to plan the last portion of opening for motor 2 in deceleration
and release it just at the end of the opening (when limit switch is working FCC 2).
If the leaf is already completely closed because abdicates the deceleration, and if the
arrest has not happened with the limit switch FCC 2, send a short impulse with the key
PS1 to pass over the following point.
At the end of the stroke in closing of the motor 2 the state of the
leds is that represented to the left side
Hold pressed Hold pressed the key PS1 to plan the time of work in closing for motor
1.
WARNING! If you want to plan the final portion of the stroke in deceleration, release the
key PS1 in the point in which you desire to continue with the low speed.
If you want to effect the whole stroke with normal speed, maintain pressed PS1 and
release it just at the end of the closing (when limit switch is working FCC 1).
Hold pressed the key PS1 to plan the last portion of opening for motor 1 in deceleration
and release it just at the end of the closing (when limit switch is working FCC 1).
If the leaf is already completely closed because abdicates the deceleration, and if the
arrest has not happened with the limit switch FCC 1, send a short impulse with the key
PS1 to pass over the following point
At the end of the stroke in closing of the motor 1 so the complete
gate the state of the leds is that represented to the left side
Send a short impulse with the key PS2;
the led REV 1 flash asking the confirmation of the time of planned work.
WARNING! If you want to repeat the setting of the time of work to this point press the key
PS1 to go to the beginning conditions.
To confirm, send a short impulse with the key PS2; the 3 leds switch on green fixed light
for 2 seconds pointing out the memorization of the time of work
Subsequently the control panel will be ready again in the initial
planning menu turning on fix red light the led REV 1.
REV 1
(red)
REV 2
SET
REV 1
(red)
REV 2
(green)
SET
REV 1
(red)
REV 2
SET
(green)
REV 1
(red)
REV 2
(green)
SET
(green)
REV 1
(red)
REV 2
SET
REV 1
(red)
REV 2
SET
(green)
REV 1
(red)
REV 2
(green)
SET
(green)
REV 1
(red)
REV 2
SET
REV 1
(red)
REV 2
SET
REV 1
(green)
REV 2
(green)
SET
(green)
REV 1
(red)
REV 2
SET
