Page 6 of 14 EQ2006 R.1.5 Rev. 02 dated 09/11/2007
Hold pressed the key PS1 to set the time of pedestrian opening;
the gate will start in opening and it will arrest itself to the release of PS1 fixing in that
point the duration of the pedestrian opening.
If you don’t want to plan the pedestrian opening give a short impulse on PS1 to pass over
the following point.
Hold pressed the key PS1 to plan the time of work of the gate in opening.
WARNING! If you want to plan the final portion of the stroke in deceleration, release the
key PS1 in the point in which you desire to continue with the low speed.
If you want to effect the whole stroke with normal speed, maintain pressed PS1 and
release it just at the end of the opening (when limit switch is working FCA 1).
Hold pressed the key PS1 to plan the last portion of opening in deceleration and release
it just at the end of the opening (when limit switch is working FCA 1).
If the leaf is already completely open because abdicates the deceleration, and if the
arrest has not happened with the limit switch FCA 1, send a short impulse with the key
PS1 to pass over the following point.
At the end of the opening the state of the leds is that represented to
left side.
Hold pressed the key PS1 to plan the time of work of the gate in closing.
WARNING! If you want to plan the final portion of the stroke in deceleration, release the
key PS1 in the point in which you desire to continue with the low speed.
If you want to effect the whole stroke with normal speed, maintain pressed PS1 and
release it just at the end of the closing (when limit switch is working FCC 1).
Hold pressed the key PS1 to plan the last portion of the closing in deceleration and
release it just at the end of the closing (when limit switch is working FCC 1).
If the leaf is already completely closed because abdicates the deceleration, and if the
arrest has not happened with the limit switch FCC 1, send a short impulse with the key
PS1 to pass over the following point.
At the end of the closing the state of the leds is that represented to
left side.
Send a short impulse with the key PS2;
the led REV 1 flash asking the confirmation of the time of planned work.
WARNING! If you want to repeat the setting of the time of work to this point press the key
PS1 to go to the beginning conditions..
To confirm, send a short impulse with the key PS2; the 3 leds switch on green fixed light
for 2 seconds pointing out the memorization of the time of work
Subsequently the control panel will be ready again in the initial
planning menu turning on fix red light the led REV 1.
REV 1
(red)
REV 2
(green)
SET
(green)
REV1
(red)
REV 2
SET
(green)
REV 1
(red)
REV 2
(green)
SET
(green)
REV 1
(red)
REV 2
SET
REV 1
(red)
REV 2
SET
(green)
REV 1
(red)
REV 2
(green)
SET
(green)
REV 1
(red)
REV 2
SET
REV 1
(red)
REV 2
SET
REV 1
(green)
REV 2
(green)
SET
(green)
REV 1
(red)
REV 2
SET
