Casio DT-X100 Series, Руководство по обслуживанию

Страница: 36 / 82

— 33 —
Orient the SPEAKER so that its lead wires come to the left side as shown below and attach it to the
U-CASE. (In the picture, note that the CUSHION/SPEAKER is intentionally removed to show you the
position of the lead wires. In reality, it is attached.)
In this case, raise the antenna cable to prevent it from being caught and set the SPEAKER. Then, return
the antenna cable as it was.
When the SPEAKER is new, assemble it after peeling off the release paper of the W-TAPE/SPEAKER,
and then attach the CUSHION/SPEAKER after assembling the HOLDER/SPEAKER.
SPEAKER
W-TAPE/SPEAKER
CUSHION/SPEAKER
Be sure that the lead wires do
not come in contact with the rib.
5-2. KEY2-UNIT and TEN-KEY-SUB-ASSY
(1) Gently insert a thin precision fl at-bladed screwdriver between the SPACER-BLOCK and KEY2 UNIT
PCB that is attached with double faced tape, raise the KEY2 UNIT PCB by peeling it off , and remove the
BLOCK/SPACER.
Insert here.
SPACER/BLOCK
KEY2 UNIT PCB
(2) Undo 2 #0 screws and raise the KEY2-UNIT.
KEY2 UNIT
#0 screws (Phillips head)