Case FARMALL 105U EP, Руководство по обслуживанию

Страница: 56 / 61

Engine - Exhaust Gas Recirculation (EGR) - Diesel Particulate Filter (DPF) exhaust treatment
Diesel Particulate Filters (DPF) - Install for periodic replacement
NOTE: For the tightening torques please refer to Diesel Particulate Filters (DPF) - Torque (10.501) .
1. Reassemble the middle part of the DPF filter with the
relevant clamp; tighten the clamp, paying attention to
the orientation of the parts.
2. Reassemble the left part of the DPF filter with the rele-
vant clamp; tighten it, paying attention to the orientation
of the parts.
NOTE: If the clamp and the gasket are rusty and in a poor condition, change them.
3. Reassemble the left-hand clamp fastening the filter on
the cradle.
4. Position the collar fastening the filter pipe to the muffler
and tighten it, tighten also the top of the collar that fixes
the pipe to the cradle.
5. Fit the filter upper heat shield back on.
6. Fit the temperature sensor back on.
NOTE: To reassemble the pressure differential unit proceed as described in chapter Diesel Particulate Filters (DPF)
- Install (10.501) .
7. Fit the hood support back on.
8. Reassemble the system heat shield and reconnect the
pressure, lambda and pressure differential sensors,
position the wiring harness and, if necessary, secure it
with ties.
9. Fit the air cleaner onto the hose connecting it to the
turbine, then secure it to the hood support with the rel-
evant screws.
10. Tighten the clamp on the hose, run the intake duct to-
wards the filter then tighten it with the relevant screws;
reconnect the connector to the clogged filter sensor.
11. Refit the hood. See Hood - Install (90.100) .
12. Reconnect the battery cable, replace the cover and
lower the steps.
47841819 24/02/2015
10.3 [10.501] / 15