Case 445/M2, Руководство по обслуживанию

Страница: 102 / 178

Figure 210
-
Assemble the cover (2, Figure 2 1 0) including gasket and
tighten the screws ( 1 , Figure 2 1 0).
-
Pull the pin outwards setting the camshaft gear free.
-
Remove the 380000988 tool locking flywheel rotation;
place the starter in its housing.
-
Connect all pipelines (from pumping elements to
injectors, bleeding recovery pipes from injectors to
pump, LDA pipeline (
1 ) and feed provided by priming
pump and lubrication pipelines).
- Connect electrical switch devices to engine stop.
Figure 211
Figure 212
1
2 3
4
757 1 5
-
On the timing side, throughout the specially appointed
port, fit the washer and screw up the fixing nut (3) to the
pump shaft. Lock the nut to the 90
− 95 Nm couple.
!
In case pump removal has been carried out while the
engine was assembled, connect acceleration cable.
76 1 34
-
Remove the hexagon shaped cap ( 1 ) from the speed
gauge box and withdraw locking pin (2) from the
camshaft.
-
Turn the locking pin (2) upsidedown and place it in its
housing: this operation enables free rotation of the
pump’s camshaft.
-
Assemble the hexagon shaped cap ( 1 ) to the speed
gauge box.
76 1 39
1
2
SECTION 3 − DUTY − INDUSTRIAL APPLICATION
68
E NG I NE S
ED. FEBUARY 2003
zs