Case 445/M2, Руководство по обслуживанию

Страница: 92 / 178

Figure 180
Figure 181
-
Tighten the screws (2) to the prescribed couple and
assemble water temperature sensor (1).
!
In order carry out a quicker adjustment of the
working slack between rocker arms and valves,
proceed as following:
Rotate the engine drive shaft, balance the valves of
cylinder 1 and adjust the valves identified by star
symbol, as indicated in the following table:
Adjust the slack between rocker arms and valves using socket
wrench (1), point wrench (3) and feeler gauge (2).
Correct working slack is:
− suction valves 0.30

0.05 mm
− exhaust valves 0.55

0.05 mm.
Figure 182
D1 D2
75703
- Insert the tappet driving rods and the Rocker Arm unit.
Before using the fixing screws again, measure them twice
as indicated in the picture, checking D1 and D2
diameters:
if
D1 − D2 < 0,1 mm the screw can be utilised again;
if D1 − D2 > 0,1 mm the screw must be replaced;
1
2
75683
75806
2
1
3
Rotate the engine drive shaft of 360 deg., balance the
valves of cylinder 6 and adjust the valves identified by
star symbol, as indicated in the following table:
Cylinder n.
Suction
Exhaust
1
2 3 4
*
*
*
*
*
−
−
−
5 6
−
−
Cylinder n.
Suction
Exhaust
1
2 3 4
−
− * −
−
−
*
*
5 6
*
*
*
−
*
−
SECTION 3 − DUTY − INDUSTRIAL APPLICATION
58
E NG I NE S
ED. FEBUARY 2003