Specifications
The following section describes the CINEMA 6 Surround Sound Processor basic specifications. The specifications are subject to
change or improvement without notice or obligation.
Audio Inputs and Output
Audio Inputs
5 stereo pairs and two 7.1-channel analog input
Digital Audio Inputs
4 coaxial (RCA), 4 Toslink
Sample Rates
44.1, 48, 88.2, 96 or 192 kHz
Accepts
16-24 bits PCM audio, Dolby Digital, Dolby Digital EX, dts and dts-ES
Main Audio Outputs
7.1 RCA, L/R, Center, LFE(Subwoofer), Side L/R, Rear L/R
Zone 2 Audio Outputs
1 RCA stereo pair
Performance Data
Analog-to-Digital Conversion
24-bit, 96 kHz(ADVANCED SEGMENT)
Digital-to-Analog Conversion
24-bit, 44.1 to 192 kHz(ADVANCED SEGMENT) operating in each channel
Frequency Response
10 Hz to 20 kHz, +0.1dB/-0.25dB, -0.75dB at 40 kHz, referenced to1 kHz
THD + Noise
Below 0.003% at 1 kHz, maximum output level
Dynamic Range
110 dB minimum, 125 typical, 22 kHz bandwidth
Signal-to-Noise Ratio
110 dB minimum, 125 typical, 22 kHz bandwidth
Input Sensitivity
200 mV rms (2 Vrms for maximum output level) at 0dB input gain
Input Impedance
100 k ohm in parallel with 150 pFd
Output Level
150 mV rms typical, 10 Vrms maximum, full-scale input signal and volume at +16dB
Output Impedance
100 ohm in parallel with 150 pFd
Video Inputs and Outputs
Video Inputs
4 composite (RCA), 4 S-video, and 3 component video
Video Outputs
2 composite (RCA, 2 monitor), 2 S-video (2 monitor)
Zone 2 Video Outputs
1 composite (RCA),1 S-video
Performance (Composite & S-video)
NTSC M, PAL, and SECAM compatible
Switching
Active
Output Level
1.0Volt peak-to-peak
Impedance
75 ohm
Input Return Loss
>40dB
Differential Gain
<0.5%
Differential Phase
<0.5
Bandwidth
>25 MHz (OSD)
K Factor
<0.3%
Gain
0.15dB
Signal/Noise Ratio
>70dB
Frequency Response
10 Hz to 10 Mhz +0.1/-0.3dB
Performance (Component Video)
3-Channel (Y, Pr, Pb), format-independent
Switching
Passive
Impedance
75 ohms
Bandwidth
>300 MHz
Insertion Loss
<3 dB
Others Specifiations
Trigger Outputs
3 power on/off triggers, +12 VDC, 0.25 amps each,
RS-232 Serial Input/Output
9-pin D-sub connectors for system control
Power Requirements
120 VAC or 220 VAC 50-60 Hz, 45 W
(4)
