CARVIN XD360 Extreme Drive, Руководство по эксплуатации

Страница: 19 / 24

19
INPUT
SETTINGS
(top 1/3 of screen, after SYSTEM) Click on A , B , or C .
LOAD / SAVE : Load preset input settings or save them to your computer.
COPY / PASTE : Copy output settings from one output to another.
FLAT : sets the input to 20Hz-20kHz, all PEQs flat and volume full (0dB).
GAIN : Set input level from 0dB (full) to -60dB(off)
PEQ : Set Parametric EQ’s for Gain (boost/cut), FREQuency and BandWidth.
DELAY : Set the delay time for the input. Right click to select units: S, Ft, M.
ROUTER
(left middle of screen)
For each OUTPUT , click on the A , B , C buttons to select output signal sources.
OUTPUT MUTES
buttons 1 to 6 (center screen, below “X-Drive” )
Click on these to mute or un-mute the individual outputs.
FREQUENCY CHART
buttons 1 to 6 (right middle of screen)
Display the frequency response of each output as a different color.
OUTPUT
SETTINGS
(bottom 1/3 of screen) Click on 1 to 6 .
LOAD / SAVE : Load preset output settings or save them to your computer.
COPY / PASTE : Copy output settings from one output to another.
FLAT : sets the output to 20Hz-20kHz, all PEQs flat and volume full (0dB).
LOW CUT and HIGH CUT : Set crossover points, filter type and rolloff (dB/oct.).
GAIN : Set output level from 0dB (full) to -60dB(off)
PEQ : Set Parametric EQ’s for Gain (boost/cut), FREQuency, and BandWidth.
LIMITER : Set the threshold for the Limiter (+18db is no limiting).
DELAY : Set the delay time for the output. Right click to select units: mS, Ft, M.
PHASE : Flip the phase 180 degrees. IN is normal, OUT is +180 deg.