Carver 33 SUPER SPORT, Руководство пользователя

Страница: 141 / 164

3327 12/04
W
INTERIZATION AND
S
TORAGE
S
ECTION
8
c. If the toilet uses seawater to flush, open the seacock that supplies
seawater to the toilet. Flush the toilet a few times to prime the
sanitation system.
d. Charge the waste tank by adding deodorizer. Use the brand of
deodorizer recommended by your Carver Dealer.
8.3.7.2 Overboard Discharge System
1. Empty the waste tank as described in 4.5.2 Emptying the Waste
Tank. Remove as much of the fresh water used in flushing the tank
as possible.
2. If the toilet uses seawater to flush, follow steps a - d below; other-
wise, proceed to step 3.
a. Close the seacock that supplies seawater to the toilet.
b. Disconnect the toilet seawater hose from the seacock.
c. Flush the toilet until all water is drained from the seawater hose.
d. Reconnect the seawater hose to the seacock. Leave the seacock
closed.
You must use a nontoxic, non-alcohol, RV-type (pink) antifreeze in your
boat’s sanitation system. Using the wrong type of antifreeze can damage
the sanitation system. The repair of such damage is not included under
the terms of the Carver Limited Warranty.
3. Flush 10 gallons of nontoxic recreational vehicle antifreeze through
the toilet.
4. Under the boat, place a large bucket under the overboard discharge
fitting to collect antifreeze pumped out later in this procedure. Refer
to 9.7.3 Thru-Hull Fittings for the exact location of the overboard
discharge fitting.
5. Open the overboard discharge seacock.
6. If your boat has the optional grey water holding system, turn the Y-
valve to select the waste tank.
7. On the Safety Breaker Panel:
a. Turn the “house” battery master disconnect switch to the “ON”
position.
Open Closed
Open Closed