The receiver and the speed controller are built into
the
Skydreamer
and generally require no
maintenance. If you would like to fly in an area
where your frequency (channel) is often used by
other modellers you should buy a pair of crystals of
another frequency. The crystal of the receiver is
changed as detailed below.
Pull out the receiver's crystal and push in the new
crystal. Make sure that it is fully inserted. (The
crystal in the transmitter must be changed at the
same time). Crystal for the transmitter (label TX)
and receiver (RX) must be of the same channel.
Check the functions of the radio system and
servos.
Your almost-ready-to-fly
Skydreamer
set
conducted at a closer distance in order to see the
includes a 4-channel radio control unit, receiver
flight attitude of the model.
and flight controller already installed in the
Skydreamer
, as well as 2 micro-servos to
Never start when batteries in the transmitter are
weak (voltage indicator in red area) otherwise your
operate the rudder and elevator. This system is
Skydreamer
could fly away out of control.
designed to have a range of 300m which means
that you can control your aeroplane up to this
distance. In practice, normal flying will be
Transmitter
from the front of the case. (A matching crystal
•
This transmitter gives a stable and adequate
will also be required for the receiver). The use
output under most climatic conditions.
of faulty crystals can
•
The frequency bands are precise and conform
damage the radio
to internationally recognised standards. They
and invalidates
are free from spurious radiation and therefore
our guarantee.
do not interfere with adjacent bands. For your
guidance the bands are displayed on the front
of the case.
•
Interchangeable plug-in crystals enable a rapid
change of frequency by simply unplugging them
4-CHANNEL RADIO CONTROL UNIT
Receiver - Changing the receiver crystal
6
5
4
3
2
1
6
5
4
3
2
1
69
RX
RX
10 SKYDREAMER CARSON R/C MODEL AIRCRAFT 50 050 5011
GB
GB
