Carrier TRANSICOLD 69UG15, Руководство по эксплуатации и обслуживанию

Страница: 29 / 66

3–1 T-375
SECTION 3
OPERATION
3.1 Generator Set Installation
The generator set is mounted under the center of the trailer chassis and is easily handled with a fork lift truck
capable of handling 907 kg. The fork lift pockets provided are accessible from either side. Mounting clamps are
designed to be attached to outside I-beam flanges only. Maximum chassis width is 97 cm on center.
1. Loosen the mounting bolts (see
Figure 3.1
) enough to push the mounting plates to the outermost position.
2. Place forks into the fork lift pockets of the generator set. Attach the safety chain between the unit and fork truck.
3. Center the generator under the chassis slide mounting plates fully onto the chassis I-beams and torque
mounting bolts to 11.1 - 12.4 m-kg. Upon completion, remove the safety chain before removing forks of fork
lift truck from the unit.
3.2 Generator Set Removal
1. Disconnect power cable to generator (if connected).
2. With fork lift in position and safety chain attached, slide mounting plates back sufficiently to clear chassis.
3. Lower and remove generator.
Figure 3.1 Generator Set Mounting - Standard Mount
1) Container Floor Cross I-Beam
2) Rear of Chassis
3) Fork Lift Pocket
4) Washer, Belleville
5) Washer, Spherical, Female
6) Tee Nut
7) Roll Pin
8) Bolt
9) Washer, Spherical, Male
10) Mounting Plate
11) Generator Frame
- - - - -
$
$ $
Road Side View
6
9
5
8
4
7
10
11
3
1
2
View A-A
3