Carp Madness XXL 2020, Инструкция по эксплуатации

Страница: 7 / 23

2. Fitting the feed flap
It is possible to equip the boat with one or two feeder flaps. That depends on your field of
application; of course, with 2 flaps the volume of the feed shafts is halved. With one flap,
even larger buoys or baitfish can be transported.
The operation works with our 6 channel remote control systems. 2 channels for the
motors, one channel for 1 or 2 feeder flaps and 3 channels remain free. At these, e.g. a
release coupling can be attached.
two feed flaps:
If you want to build 2 flaps, you must first divide the feed chute. For this purpose, bulges
are mounted in the boat at the bottom of the shaft. In this a plate is glued, which is
included in the delivery.
If the shaft is divided, the exact size of each flap can be determined.
The two feed flaps are riveted or bolted with the stainless-steel hinges and also fastened
to the boat fuselage. A smooth running is important.
One feed flap:
Put the fuselage upside down on the table. The enclosed feeder flap can either be applied
by plan or fitted (then the form has to be traced exactly, put on the flap, fix it with adhesive
tape and mark it exactly with a white edding and then cut it out)
If the flap has to be applied, the shape can be used.
Recommendation: use a fine sanding paper to sand the feed flap all the way around to
remove any sharp edges. These could later damage the cord.
We recommend screwing the flap with the attached hinges. These hinges are made of
stainless steel. Therefore, also use screws or rivets made of aluminum / stainless steel.
Make sure that the flap can still turn
777