Carp Madness XXL 2020, Инструкция по эксплуатации

Страница: 16 / 23

Mounting the lid:
The diodes supplied by us are pre-assembled and ready. These diodes only need to
be screwed into the fuselage.
After assembly, these should still be sealed. Be sure to secure the screwing of the
sockets as this area of the boat will be difficult to reach after gluing.
We recommend to connect the diodes parallel, because then the other diodes will
still work, if one fails. To do this, connect all + poles and all - poles of the LEDs
together.
This line is again soldered to + and - at the output point of the electronics unit.
Important: The power for the lighting is taken from the electronics unit.
The electronic unit must be inserted and connected in accordance with the label and
instructions of the individual components (see lower shell).
The attachment is a double-sided adhesive tape. The cables must of course be laid
clean after a successful test.
Make sure that the components are still accessible after the hull and lid have been
glued together. It is important to pay attention to the correct polarity.
From the inside, the acrylic glass and the voltmeter should be glued on.
16 16 16