Carp Madness XXL 2020, Инструкция по эксплуатации

Страница: 13 / 23

3. Attaching and connecting the electronics
The electronics must be inserted and connected in accordance to the photos and
instructions of the individual components. The attachment is a double-sided adhesive
tape. The cables must of course be laid clean after a successful test.
Make sure that the components are still accessible after the hull and lid have been
glued together. It is important to pay attention to the correct polarity.
The 2.4 GHz system does not need an antenna on the receiver. The receiver must be
taught to the transmitter as needed in accordance with the operating instructions.
It is important that the antenna of the receiver is as high as possible, i. later also as
high as possible above the water level. Likewise, no power lines may be located
directly next to the receiver.
The remote control is programmed by us with an optimal program for the boat. Do not
adjust anything on the radio, otherwise the warranty will be forfeited. Every change is
stored in the device and can be read out by us.
We recommend the following recipient assignment:
Left engine in slot 1 (seen from the rear)
Right engine in slot 2
Dimmable light on 3
1 piece or 2 piece flap on 4
Release couplings 5 or 6
Important: the dark wire of the 3-core cable must point outwards when plugging in on
the receiver
The electronic unit must be inserted and connected in accordance with the label and
instructions of the individual components.
The boat should be slightly leaned backwards in the water in the unloaded state. This
can be tested very well in the bathtub. Just balance it in the bathtub. This is very
important to steer the boat later optimal. Take your time.
13 13 13