Carlton SP4012, Руководство пользователя

Страница: 49 / 139

SP4012 MACHINE MAINTENANCE
29
•
Grease the bearing supported stub shaft
every 1000 hours of operation using
Texaco
®
Starplex II grease. The grease
fitting is easily accessible behind the V-
belt guard. Apply grease using a hand
held grease gun until the pin extends
from the pressure relief valve (located
180
°
from grease fitting on the bearing).
Wipe off excess grease. Excess grease
will attract dirt.
•
A grease fitting is on the end of the stub
shaft to grease the spline coupling.
Apply 2 to 3 shots of grease
approximately every 1000 hours of
operation. Wipe off excess grease.
Excess grease will attract dirt. DO
NOT over grease, over greasing could
cause a hydraulic type lift on seals .
•
Grease engine slide assembly every 15 –
20 hours of operation with
approximately 2 to 4 shots of Texaco
Starplex II grease. (Total of 6 grease
fittings.)
DO NOT OVER GREASE.
•
Grease engagement lever every 15 – 20
hours of operation with approximately 2
to 4 shots of Texaco Starplex II grease.
ENGAGEMENT LEVER
GREASE FITTINGS
ENGINE SLIDE ASSEMBLY
GREASE FITTINGS (TYP 6)
PRESSURE RELIEF VALVE
PIN WILL EXTEND WHEN
ENOUGH GREASE HAS
BEEN APPLIED.
GREASE FITTING