Carlton SP4012, Руководство пользователя

Страница: 71 / 139

SP4012 SERVICING CUTTER WHEEL
51
SAFETY
•
NEVER SERVICE A MACHINE WITH THE ENGINE RUNNING, SEVERE
PERSONAL INJURY COULD OCCUR. TURN ENGINE OFF THEN REMOVE
IGNITION KEY AND DISCONNECT POSITIVE BATTERY CABLE TO AVOID
STARTING MACHINE ACCIDENTALLY.
•
CUTTER WHEEL MUST BE DISENGAGED BEFORE TURNING ENGINE
ON/OFF AND BEFORE SERVICING A MACHINE. OTHERWISE SEVERE
PERSONAL INJURY COULD OCCUR AS WELL AS MACHINE DAMAGE.
•
ALL MACHINE PARTS MUST COME TO A COMPLETE STOP AND HAVE
TIME TO COOL COMPLETELY BEFORE SERVICING A MACHINE OR
SEVERE INJURY COULD OCCUR, POSSIBLY SERIOUS BURNS AND/OR
DISMEMBERMENT.
•
DO NOT OPERATE A MACHINE WITHOUT A COMPLETE NUMBER OF
TEETH IN THE CUTTER WHEEL PROPERLY INSTALLED. EXCESSIVE
MACHINE VIBRATION WILL OCCUR CAUSING PREMATURE BEARING
FAILURE AND EQUIPMENT DAMAGE.
•
PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
•
There are twenty (20) teeth to a complete set on
the model SP4012. Two (2) straight teeth, nine
(9) left 45° teeth and nine (9) right 45° teeth.
•
A locking pin is provided to hold cutter wheel in
position during tooth removal and re-
installation. Locking pin will only lock on outer
teeth.
NEVER PLACE HAND ON CUTTER
WHEEL TO HOLD IN PLACE WHILE
CHANGING TEETH. BE SURE TO
REMOVE PIN BEFORE OPERATING.
•
A Tooth Setting Gauge (P/N 0450111) is
provided with each machine for proper tooth
installation. Line all teeth up with the inside
edge of the groove in the gauge. Set
ALL teeth
to this edge with gauge against pocket, not
against cutter wheel.
See Cutter Wheel
Assembly for breakdown.